v6.03.154 SSNP154 — NAFEMS contact validation benchmark 1: cylinder roller contact

Summary:

This problem is the first test case of a benchmark NAFEMS for validating touch-friction. The benchmark references are obtained with the Abaqus and MARC codes.

This test models a Hertz contact with and without friction between a solid and a cylinder of different stiffness meshed with different fineness.

An analytical solution exists for the frictionless case.

This test includes 6 models to test:

• linear and quadratic elements,

• the “CONTINUE” contact treatment formulations without and with friction.

• “DISCRETE” frictionless contact treatment formulations

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
• 2. Benchmark solution
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainties about the solution
  • 2.4. Bibliographical reference
• 3. Modeling A
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
  • 3.4. notes
• 4. B modeling
  • 4.1. Characteristics of modeling
  • 4.2. Characteristics of the mesh
  • 4.3. Tested sizes and results
  • 4.4. notes
• 5. C modeling
  • 5.1. Characteristics of modeling
  • 5.2. Characteristics of the mesh
  • 5.3. Tested sizes and results
  • 5.4. notes
• 6. D modeling
  • 6.1. Characteristics of modeling
  • 6.2. Characteristics of the mesh
  • 6.3. Tested sizes and results
  • 6.4. notes
• 7. E modeling
  • 7.1. Characteristics of modeling
  • 7.2. Characteristics of the mesh
  • 7.3. Tested sizes and results
  • 7.4. notes
• 8. F modeling
  • 8.1. Characteristics of modeling
  • 8.2. Characteristics of the mesh
  • 8.3. Tested sizes and results
  • 8.4. notes
• 9. Summary of results