6. D modeling#
6.1. Characteristic of modeling#
The modeling used is two-dimensional under plane stress (C_ PLAN). The aim of this modeling is to validate the large deformation algorithm GDEF_LOG in C_ PLAN. We therefore compare the results with those obtained by GDEF_LOG in modeling \(C\), which treats an equivalent problem in 3D.
6.2. Characteristics of the mesh#
The mesh consists of a linear quadrangular mesh (with 4 knots).
Figure 5: Meshing identical to that of modeling \(B\)
6.3. Tested sizes and results#
VMIS_ISOT_LINE behavior with GDEF_LOG
Imposed displacement |
Size tested |
Reference \((\mathit{MPa})\) |
Tolerance (%) |
\(500\mathit{mm}\) |
|
1006.9 |
0.1 |
\(500\mathit{mm}\) after rotation |
SIEQ_ELGA |
1006.9 |
0.1 |
\(700\mathit{mm}\) |
|
1256.1 |
0.1 |