5. C modeling#
5.1. Characteristics of C modeling#
3D modeling.
Model DRUCK_PRAGER with linear negative work hardening.
Number of nodes |
\(20\) |
|||
Number of meshes |
\(7\) |
That is: |
||
QUAD8 |
|
|||
HEXA20 |
|
Cube geometry \((m)\):
Center \(O(0.\mathrm{,0}\mathrm{.}\mathrm{,0}\mathrm{.})\)
Side \(C=1m\)
Mesh groups:
\(\mathrm{BAS}\): surface of the cube belonging to the \(Z=-0.5\) plane
\(\mathrm{HAUT}\): surface of the cube belonging to the \(Z=+0.5\) plane
\(\mathrm{DROITE}\): surface of the cube belonging to the \(Y=+0.5\) plane
\(\mathrm{GAUCHE}\): surface of the cube belonging to the \(Y=-0.5\) plane
\(\mathrm{DERRIERE}\): surface of the cube belonging to the \(X=-0.5\) plane
\(\mathrm{DEVANT}\): surface of the cube belonging to the \(X=+0.5\) plane
5.2. Tested sizes and results#
Grandeur |
Point |
\(\mathrm{Inst}\) |
Reference |
Tolerance (\(\text{\%}\)) |
\(\mathrm{SIXX}(\mathrm{Pa})\) |
A |
\(2.0\) |
\(-2.0\mathrm{E6}\) |
0.1 |
\(\mathrm{SIZZ}(\mathrm{Pa})\) |
A |
\(1.07\) |
\(-8.09\mathrm{E6}\) |
0.1 |
\(1.16\) |
\(-8.20\mathrm{E6}\) |
0.1 |
||
\(1.34\) |
\(-6.89\mathrm{E6}\) |
0.1 |
||
\(1.53\) |
\(-5.80\mathrm{E6}\) |
0.1 |
||
\(\mathrm{V1}\) |
A |
\(1.07\) |
\(0\) |
0.1 |
\(1.16\) |
\(1.99E-3\) |
0.1 |
||
\(1.34\) |
\(6.35E-3\) |
0.1 |
||
\(1.53\) |
\(1.09E-2\) |
0.1 |
||
\(\mathrm{DZ}(m)\) |
A |
\(1.07\) |
\(-1.05E-3\) |
0.1 |
\(1.16\) |
\(-2.40E-3\) |
0.1 |
||
\(1.34\) |
\(-5.10E-3\) |
0.1 |
||
\(1.53\) |
\(-7.95E-3\) |
0.1 |