5. C modeling

Validation of the 3D joint with law JOINT_MECA_RUPT

5.1. Characteristics of modeling

3D modeling for the elastic element.

3D modeling_ JOINT for the joint element

5.2. Characteristics of the mesh

Number of knots: 9

The elastic element is a PENTA6.

The joint element is a degenerate PENTA6 (knots combined).

5.3. Tested sizes and results

Modes \(I\) and \(\mathrm{II}\)

Identical to modeling A. We just note that \(\mathit{FN}\mathrm{=}\mathit{SIGN}\mathrm{/}2\), because the contact area is equal to \(1/2\).

Fashion \(\mathrm{III}\)

The joint is opened in \(I\) mode until partial damage occurs, then it is stressed in \(\mathrm{III}\) mode. Tangential stiffness slopes are tested at two values of normal apertures.