3. Modeling A#

3.1. Characteristics of modeling#

Modeling A only aims to validate the functionalities for calculating the priming factor in the operator POST_RCCM based on the constraints directly given.

There is therefore no mesh or mechanical calculation in this modeling.

3.2. Tested values and results#

The calculation of the priming factor is tested with:

  • different cases of min and max stresses producing the same amplitude of variation (100);

  • a case of combining 2 transients producing different constraints;

  • a case of negative values;

  • a case with a number of occurrences.

The calculated priming factor values are exactly equal to the analytical reference values.