Modeling A
==============


Characteristics of modeling
-----------------------------------

Modeling A only aims to validate the functionalities for calculating the priming factor in the operator POST_RCCM based on the constraints directly given.

There is therefore no mesh or mechanical calculation in this modeling.


Tested values and results
----------------------------

The calculation of the priming factor is tested with:


* different cases of min and max stresses producing the same amplitude of variation (100);


* a case of combining 2 transients producing different constraints;


* a case of negative values;


* a case with a number of occurrences.

The calculated priming factor values are exactly equal to the analytical reference values.