4. B modeling

4.1. Characteristics of modeling

The reinforcing plies on the lower and upper faces are represented by a grid model.

4.2. Characteristics of the mesh

The mesh is the same as that of modeling A.

4.3. Tested sizes and results

We test the vertical displacement at the end of the plate, as well as the deformation and the stress in the grid at the end of the plate.

Identification	Component	Reference Type	Reference Value	Tolerance
DEPL — POINT_1	DZ	“AUTRE_ASTER”	-87.1E-6	4%

Identification	Component	Reference Type	Tolerance
DEPL — POINT_1	DZ	“NON_REGRESSION”	1.E-6
EPSI_NOEU — POINT_2	EXX	“NON_REGRESSION”	1.E-6
SIEF_NOEU — POINT_2	SIXX	“NON_REGRESSION”	1.E-6