21. S modeling#
21.1. Characteristics of modeling#
This modeling is used to verify the construction of a reduced base on VARI_ELGA.
We only select the component NOM_VARI =” EPSEQ “.
21.2. Characteristics of the mesh#
The mesh contains 27 elements of type HEXA8.
21.3. Tested sizes and results#
Identification |
Reference type |
Knit \({CellInRID}\) - VARI_ELGA/EPSEQ —Point 1 |
|
Knit \({CellOutRID}\) - VARI_ELGA/EPSEQ —Point 1 |
|
These values are used as a reference to verify the base produced on VARI_ELGA that we rebuilt by modal combination (command CREA_CHAMP/ASSE).
From a base built with OPERATION =” POD “and TOLE_SVD = \({1,0}\times {10}^{-3}\) in DEFI_BASE_REDUITE:
Identification |
Reference Type |
Tolerance |
Knit \({CellInRID}\) - VARI_ELGA/EPSEQ —Point 1 |
|
|
Knit \({CellOutRID}\) - VARI_ELGA/EPSEQ —Point 1 |
|
|
From a base built with OPERATION =” POD_INCR “and TOLE_SVD = \({1,0}\times {10}^{-3}\) and TOLE_INCR = \({1,0}\times {10}^{-3}\) in DEFI_BASE_REDUITE:
Identification |
Reference Type |
Tolerance |
Knit \({CellInRID}\) - VARI_ELGA/EPSEQ —Point 1 |
|
|
Knit \({CellOutRID}\) - VARI_ELGA/EPSEQ —Point 1 |
|
|