v6.03.502 SSNP502 - Crush of a polyurethane ring between two non-deformable plates with friction

Summary:

The test consists in simulating the crushing under plane stresses of a circular elastic polyurethane ring by two symmetric, non-deformable plates. The objective is to test the functionalities related to contact. This test involves gluing over a contact zone of considerable length with the presence of large elastic deformations.

A symmetric imposed displacement is applied to the two plates; the resultant force as well as the contact pressure for various points in contact are compared with the results obtained in the reference article.

In the three proposed models, the ring is modeled with QUAD4en plane constrained cells:

• modeling B, a contact with friction treated with the penalization method has been defined between the plate and the ring,

• modeling C, a contact with friction treated with the continuous method has been defined between the plate and the ring.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Benchmark solution
  • 2.1. Calculation method used for the reference solution
  • 2.2. Benchmark results
  • 2.3. Uncertainties about the solution
  • 2.4. Bibliographical references
• 3. B modeling
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
  • 3.4. notes
• 4. C modeling
  • 4.1. Characteristics of modeling
  • 4.2. Characteristics of the mesh
  • 4.3. Tested sizes and results
  • 4.4. note
• 5. Summary of results