3. Modeling A#
3.1. Characteristics of modeling#
We use C_ PLAN modeling. The main constraints ratio \({\sigma }_{2}\mathrm{/}{\sigma }_{1}\) is set to \(0.52\).
3.2. Characteristics of the mesh#
The mesh contains 1 element of type QUAD4.
3.3. Tested sizes and results#
We test the deformations and stresses at node \(N1\) in Figure.
Identification |
Increment |
Reference Type |
Reference Value |
Tolerance |
Constraint ysy |
7 |
“ANALYTIQUE” |
\(-10842857\mathit{Pa}\) |
|
Deformity â yy |
7 |
“ANALYTIQUE” |
\(-\mathrm{3,00E-004}\) |
|
Constraint ysy |
69 |
“ANALYTIQUE” |
\(-42428571\mathit{Pa}\) |
|
Table 3.3-1 : Summary of TEST_RESU
3.4. notes#
The first two measurement points allow you to compare the slope at the origin of the Stress-Deformation curve. The last point corresponds to the breaking stress.