3. Modeling A#
3.1. Characteristics of modeling#
The modeling used in the test case is as follows:
Elements \(\mathrm{2D}\) “ AXIS “ ( QUA4 )
Figure 3.1-a: Geometry and mesh of the modeling used.
Cutting: 1 QUAD4 mesh along the \(x\) axis
1 QUAD4 mesh along the \(y\) axis
Knots:
\(A\): knit \(\mathrm{M1}\) knot \(\mathrm{N1}\)
\(B\): knit \(\mathrm{M1}\) knot \(\mathrm{N2}\)
\(C\): knit \(\mathrm{M1}\) knot \(\mathrm{N3}\)
\(D\): knit \(\mathrm{M1}\) knot \(\mathrm{N4}\)
3.2. Characteristics of the mesh#
Number of knots: 4
Number of meshes and types: 1 QUAD4, 3 SEG2.
3.3. Tested sizes and results#
Identification |
Field |
Size |
Reference |
Tolerance |
|
\(t=\mathrm{200s}\) \(\mathrm{M1}\) Point 1 |
|
|
-5.40000000E+02 |
1.00E -04% |
|
\(t=\mathrm{200s}\) \(\mathrm{N2}\) |
|
DX |
4.11705882E-03 |
1.00E -04% |
|
\(t=\mathrm{200s}\) \(\mathrm{M1}\) Point 1 |
|
V1 |
V1 |
4.32941176E-04 |
1.00E -04% |
\(t=\mathrm{400s}\) \(\mathrm{M1}\) Point 1 |
|
|
-6.15143448E+02 |
1.00E -04% |
|
\(t=\mathrm{400s}\) \(\mathrm{N2}\) |
|
DX |
8.92077868E-03 |
1.00E -04% |
|
\(t=\mathrm{400s}\) \(\mathrm{M1}\) Point 1 |
|
V1 |
V1 |
3.21321491E-03 |
1.00E -04% |