7. Modeling E

7.1. Characteristics of modeling

We use a 3D_ FLUIDE, 3D, FLUI_STRU,,, 3D_,, 3D_ ABSO and 3D_ FLUI_ABSO modeling in coupled linear dynamics (formulation \((u,\mathrm{\psi })\)). IFS

7.2. Characteristics of the mesh

The characteristics of the mesh are identical to the C modeling (see paragraph 5.2).

7.3. Tested sizes and results

We test the accelerations at time \(t=0.98s\) at the post-processing points for the X and Y directions:

Table 7.3-1: Quantities tested for modeling E

Identification	Reference type
A-AX node	AUTRE_ASTER
A-AY knot	AUTRE_ASTER
B-AX node	AUTRE_ASTER
B-AY knot	AUTRE_ASTER
C-AX node	AUTRE_ASTER
C-AY knot	AUTRE_ASTER
D-AX node	AUTRE_ASTER
D-AY node	AUTRE_ASTER

These values are compared directly with the solution obtained in the modeling D. In general, the values obtained are practically identical with a maximum error of the order of 1−08%.