Modeling E
==============


Characteristics of modeling
-----------------------------------

We use a 3D_ FLUIDE, 3D, FLUI_STRU,,, 3D_,, 3D_ ABSO and 3D_ FLUI_ABSO modeling in coupled linear dynamics (formulation :math:`(u,\mathrm{\psi })`). IFS


Characteristics of the mesh
----------------------------

The characteristics of the mesh are identical to the C modeling (see paragraph :ref:`5.2 <RefNumPara__1274_169140117>`).


Tested sizes and results
------------------------------

We test the accelerations at time :math:`t=0.98s` at the post-processing points for the X and Y directions:

Table 7.3-1: Quantities tested for modeling E

.. csv-table::

    "**Identification**", "**Reference type**"
    "A-AX node", "AUTRE_ASTER"
    "A-AY knot", "AUTRE_ASTER"
    "B-AX node", "AUTRE_ASTER"
    "B-AY knot", "AUTRE_ASTER"
    "C-AX node", "AUTRE_ASTER"
    "C-AY knot", "AUTRE_ASTER"
    "D-AX node", "AUTRE_ASTER"
    "D-AY node", "AUTRE_ASTER"


These values are compared directly with the solution obtained in the modeling D. In general, the values obtained are practically identical with a maximum error of the order of **1−08%**.