v6.04.163 SSNV163 - Self-creep calculation with models BETON_UMLV and BETON_BURGER

Summary:

This test makes it possible to validate the clean creep models BETON_UMLV and BETON_BURGER. The results of this test are compared with the analytical solutions (BETON_UMLV) or obtained according to an explicit integration diagram (BETON_BURGER) for three types of models: \(\mathrm{3D}\), axisymmetric and plane constraints.

Modeling A: Clean creep test with model BETON_UMLV and 3D modeling.

Modeling B: Clean creep test with model BETON_UMLV and modeling AXIS.

C modeling: Clean creep test with model BETON_UMLV and model C_ PLAN.

Modeling D: Clean creep test with model BETON_BURGER and 3D modeling.

Modeling E: Clean creep test with model BETON_BURGER and modeling AXIS.

F modeling: Clean creep test with model BETON_BURGER and model C_ PLAN.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Benchmark solution
  • 2.1. Solutions obtained for model BETON_UMLV
  • 2.2. Solutions obtained for model BETON_BURGER
  • 2.3. Reference quantities and results
  • 2.4. Uncertainty about the solution
  • 2.5. Bibliographical references
• 3. Modeling A
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
• 4. B modeling
  • 4.1. Characteristics of modeling
  • 4.2. Characteristics of the mesh
  • 4.3. Tested sizes and results
• 5. C modeling
  • 5.1. Characteristics of modeling
  • 5.2. Characteristics of the mesh
  • 5.3. Tested sizes and results
• 6. D modeling
  • 6.1. Characteristics of modeling
  • 6.2. Characteristics of the mesh
  • 6.3. Tested sizes and results
• 7. Modeling E
  • 7.1. Characteristics of modeling
  • 7.2. Characteristics of the mesh
  • 7.3. Tested sizes and results
• 8. F modeling
  • 8.1. Characteristics of modeling
  • 8.2. Characteristics of the mesh
  • 8.3. Tested sizes and results
• 9. Summary of results