3. Modeling A#
3.1. Characteristics of modeling#
We use a D_ PLAN modeling.
The contact between the half-ring and the block is frictionless.
3.2. Characteristics of the mesh#
The mesh contains 240 elements of type QUAD4.
3.3. Tested sizes and results#
The movement is tested on two points in the contact zone. Point \(A\), located in the middle in \(X=125\mathit{mm}\) and point \(B\), located in \(X=23/30\ast 250\mathit{mm}\), the aim being to always have one of the two points in contact during the calculation, despite the deformation of the half-ring.
Identification |
Reference Type |
Tolerance |
Point \(A\) - \(\mathrm{DX}\) |
“NON_REGRESSION” |
0.001% |
Point \(A\) - \(\mathit{DY}\) |
“NON_REGRESSION” |
0.001% |
Point \(A\) - \(\text{LAGS\_C}\) |
“NON_REGRESSION” |
0.001% |
Point \(B\) - \(\mathrm{DX}\) |
“NON_REGRESSION” |
0.001% |
Point \(B\) - \(\mathit{DY}\) |
“NON_REGRESSION” |
0.001% |
Point \(B\) - \(\text{LAGS\_C}\) |
“NON_REGRESSION” |
0.001% |