v6.03.140 SSNP140 - Tensile test on an elastoplastic perforated plane using the IMPLEX method

Summary:

This test case is used to validate the implementation of the IMPLEX resolution method. The test case studied is a tensile test of a flat specimen with holes. The solution obtained with method IMPLEX is very close to that obtained with the Newton-Raphson method.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Benchmark solutions
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainty about the solution
  • 2.4. Bibliographical references
• 3. Modeling A
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
• 4. B modeling
  • 4.1. Characteristics of modeling
  • 4.2. Characteristics of the mesh
  • 4.3. Tested sizes and results
• 5. D modeling
  • 5.1. Modeling characteristics and meshes
  • 5.2. Tested sizes and results
• 6. E modeling
  • 6.1. Modeling characteristics and meshes
  • 6.2. Tested sizes and results
• 7. F modeling
  • 7.1. Modeling characteristics and meshes
  • 7.2. Tested sizes and results
• 8. G modeling
  • 8.1. Modeling characteristics and meshes
  • 8.2. Tested sizes and results
• 9. Summary of results