v3.04.303 SSLV303 - Built-in cylinder under own weight and pressure

Summary:

The aim of the test is to validate a gravity load as well as a pressure, based on a 2D analysis with Fourier series decomposition of the load.

Two models are adopted for this analysis; they differ in terms of the keyword used to define severity:

1. modeling A: to validate the keyword PESANTEUR,

2. modeling B: to validate the FORCE_INTERNE keyword.

The gravity is calculated in mode 1, and the pressure applied is given in mode 1.

The two load cases are combined and compared with a numerical calculation in 3D modeling (model C).

A fourth modeling (D) is built in order to validate the FORCE_INTERNE keyword defined from a function.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Benchmark solution
  • 2.1. Calculation method used for the reference solution
  • 2.2. Benchmark results
  • 2.3. Uncertainty about the solution
  • 2.4. Bibliographical reference
• 3. Modeling A
  • 3.1. Characteristics of modeling A
  • 3.2. Characteristics of the mesh
  • 3.3. Tested values
  • 3.4. notes
  • 3.5. Contents of the results file
• 4. B modeling
  • 4.1. Characteristics of B modeling
  • 4.2. Characteristics of the mesh
  • 4.3. Tested values
  • 4.4. notes
  • 4.5. Contents of the results file
• 5. C modeling
  • 5.1. Characteristics of C modeling
  • 5.2. Characteristics of the mesh
  • 5.3. Tested values
  • 5.4. notes
• 6. D modeling
  • 6.1. Characteristics of modeling D
  • 6.2. Characteristics of the mesh
  • 6.3. Tested values
  • 6.4. notes
  • 6.5. Contents of the results file
• 7. Summary of results