v2.03.115 SDLS115 — Comparison with the analytical solution of a plate under tension

Summary:

This test validates the basic functioning of modeling DKT for a transient calculation with an explicit numerical integration diagram using the DYNA_NON_LINE operator. The plate is subject to the boundary conditions corresponding to simple traction, making it possible to recover the analytically calculated response.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Reference solution
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainty about the solution
  • 2.4. Bibliographical references
• 3. Modeling A
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
• 4. B modeling
  • 4.1. Characteristics of modeling
  • 4.2. Boundary conditions and loads
  • 4.3. Characteristics of the mesh
  • 4.4. Tested sizes and results
• 5. Summary of results