v1.01.293 ZZZZ293 — Validation of the position of the sub-points of multifibre beams

Summary:

This test validates the calculation of the position of the integration sub-points in the global coordinate system for modeling POU_D_EM and POU_D_TGM. An elementary mechanical calculation is carried out in order to allow the creation of a table with CREA_TABLE from the result. Only the coordinates of a few sub-points are tested in the table.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
• 2. Benchmark solution
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainties about the solution
• 3. Modeling A
  • 3.1. Characteristics of the mesh
  • 3.2. Characteristics of modeling
  • 3.3. Tested values and results
• 4. B modeling
  • 4.1. Characteristics of the mesh
  • 4.2. Characteristics of modeling
  • 4.3. Tested values and results
• 5. C modeling
  • 5.1. Characteristics of the mesh
  • 5.2. Characteristics of modeling
  • 5.3. Tested values and results
• 6. D modeling
  • 6.1. Characteristics of the mesh
  • 6.2. Characteristics of modeling
  • 6.3. Tested values and results
• 7. Summary of results