5. C modeling: axisymmetric mechanical model#

5.1. Boundary conditions#

Segment AB is embedded. The Y and Z directions are blocked on this segment.

5.2. Loads#

Pressure:

A unit pressure PX is applied to the inner skin (line AGFE).

A \(\mathit{PY}=\frac{R\stackrel{2}{i}}{R\stackrel{2}{e}-R\stackrel{2}{i}}\) shape effect is applied at the end of the model on the ED segment.

Flexion:

A single force is applied to the skin elements of the thin end: PY=1

Twist:

A single force is applied to the skin elements of the thin end: PZ=1

5.3. Meshing#

The mesh is identical to that of modeling A. Before calculation, this linear mesh is converted into a quadratic mesh.

5.4. Results#

The mechanical stresses are extracted from the calculation result by the operator MACR_LIGN_COUP.

The constraint result of this calculation is printed for the FC segment by the operator IMPR_TABLE and by the operator IMPR_OAR.

It was verified that the two tables were the same at the 5th node of the cut, (4.50526E-03 of the inner skin), with the difference in the conversion of the Pa stresses to within MPa.

Identification

Reference type

Value

NB_VALE

D GRESSION

380

VALE_CALC

D GRESSION

0.2142287716211131