v6.08.104 SSND104 - Validating behavior DRUCK_PRAG_N_A

Summary:

This test concerns the case of a single mesh for the two models A and B in order to compare the Drucker-Prager behaviors in the associated and non-associated version. In modeling A, the idea is to choose a parameter P_ ULTM that is large enough for both laws to be assimilated to perfect plasticity. Therefore, cross-validation of these two behaviors is undertaken. In B modeling, the material parameters are more ordinary and the aim is to have a validation in NON - REGRESSION.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
• 2. Modeling A
  • 2.1. Characteristics of modeling
  • 2.2. Characteristics of the mesh
  • 2.3. Tested sizes and results
• 3. B modeling
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
• 4. Summary of results