v6.04.219 SSNV219 — Method of manufactured solutions in 3D contact and large deformations

Summary:

The objective of this test is to verify the modeling of 3D contact in large deformations using the method of manufactured solutions [bib1].

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Reference solution
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainty about the solution
  • 2.4. Bibliographical references
• 3. Modeling A
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
• 4. B modeling
  • 4.1. Characteristics of modeling
  • 4.2. Characteristics of the mesh
  • 4.3. Tested sizes and results
• 5. C modeling
  • 5.1. Characteristics of modeling
  • 5.2. Characteristics of the mesh
  • 5.3. Tested sizes and results
• 6. D modeling
  • 6.1. Characteristics of modeling
  • 6.2. Characteristics of the mesh
  • 6.3. Tested sizes and results
• 7. E modeling
  • 7.1. Characteristics of modeling
  • 7.2. Characteristics of the mesh
  • 7.3. Tested sizes and results
• 8. F modeling
  • 8.1. Characteristics of modeling
  • 8.2. Characteristics of the mesh
  • 8.3. Tested sizes and results
• 9. G modeling
  • 9.1. Characteristics of modeling
  • 9.2. Characteristics of the mesh
  • 9.3. Tested sizes and results
• 10. H modeling
  • 10.1. Characteristics of modeling
  • 10.2. Characteristics of the mesh
  • 10.3. Tested sizes and results
• 11. Modeling I
  • 11.1. Characteristics of modeling
  • 11.2. Characteristics of the mesh
  • 11.3. Tested sizes and results
• 12. J modeling
  • 12.1. Characteristics of modeling
  • 12.2. Characteristics of the mesh
  • 12.3. Tested sizes and results
• 13. K modeling
  • 13.1. Characteristics of modeling
  • 13.2. Characteristics of the mesh
  • 13.3. Tested sizes and results
• 14. L modeling
  • 14.1. Characteristics of modeling
  • 14.2. Characteristics of the mesh
  • 14.3. Tested sizes and results
• 15. L modeling
  • 15.1. Characteristics of modeling
  • 15.2. Characteristics of the mesh
  • 15.3. Tested sizes and results
• 16. Summary of results