v6.04.187 SSNV187 - Validation of the ELAS_HYPER law on a cube

Summary:

This test makes it possible to validate the hyper-elastic behavior of the Signorini type (material ELAS_HYPER with or without MFront). We rely on an elementary test in plane deformations and in \(\mathrm{3D}\), compared to an analytical reference.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
• 2. Benchmark solution
  • 2.1. Calculation method
• 3. Bibliographical references
• 4. Modeling A
  • 4.1. Characteristics of modeling
  • 4.2. Characteristics of the mesh
  • 4.3. Tested sizes and results
• 5. B modeling
  • 5.1. Characteristics of modeling
  • 5.2. Characteristics of the mesh.
  • 5.3. Tested sizes and results
• 6. C modeling
  • 6.1. Characteristics of modeling
  • 6.2. Characteristics of the mesh
  • 6.3. Tested sizes and results
• 7. D modeling
  • 7.1. Characteristics of modeling
  • 7.2. Characteristics of the mesh
  • 7.3. Tested sizes and results
• 8. Modeling I
  • 8.1. Characteristics of modeling
  • 8.2. Characteristics of the mesh
  • 8.3. Tested sizes and results
• 9. J modeling
  • 9.1. Characteristics of modeling
  • 9.2. Characteristics of the mesh
  • 9.3. Tested sizes and results
• 10. K modeling
  • 10.1. Characteristics of modeling
  • 10.2. Characteristics of the mesh
  • 10.3. Tested sizes and results
• 11. Q modeling
  • 11.1. Characteristics of modeling
  • 11.2. Characteristics of the mesh
  • 11.3. Tested sizes and results
• 12. N modeling
  • 12.1. Characteristics of modeling
  • 12.2. Characteristics of the mesh
  • 12.3. Tested sizes and results
• 13. O modeling
  • 13.1. Characteristics of modeling
  • 13.2. Characteristics of the mesh
  • 13.3. Tested sizes and results
• 14. P modeling
  • 14.1. Characteristics of modeling
  • 14.2. Characteristics of the mesh
  • 14.3. Tested sizes and results
• 15. S modeling
  • 15.1. Characteristics of modeling
  • 15.2. Characteristics of the mesh
  • 15.3. Tested sizes and results
• 16. T modeling
  • 16.1. Characteristics of modeling
  • 16.2. Characteristics of the mesh
  • 16.3. Tested sizes and results
• 17. U modeling
  • 17.1. Characteristics of modeling
  • 17.2. Characteristics of the mesh
  • 17.3. Tested sizes and results
• 18. V modeling
  • 18.1. Characteristics of modeling
  • 18.2. Characteristics of the mesh
  • 18.3. Tested sizes and results
• 19. X modeling
  • 19.1. Characteristics of modeling
  • 19.2. Characteristics of the mesh
  • 19.3. Tested sizes and results
• 20. Y modeling
  • 20.1. Characteristics of modeling
  • 20.2. Characteristics of the mesh
  • 20.3. Tested sizes and results
• 21. Summary of results