6. D modeling

6.1. Characteristics of modeling

Method UPWIND without an auxiliary grid is used by PROPA_FISS.

6.2. Characteristics of the mesh

The same mesh as that of modeling A. is used.

6.3. Tested sizes and results

We extract the normal (\(\mathit{LSN}\)) and tangent (\(\mathit{LST}\)) level set using the POST_RELEVE_T operator using the operator and we check that the maximum and minimum values remain included in the capture circle of the nodes tested around the crack front, i.e. \(2/3\):

\(\mathit{Propag.}i\)	\(\mathit{Max}{\mathit{LSN}}_{i}\)	\(\mathit{Min}{\mathit{LSN}}_{i}\)		\(\mathit{Max}{\mathit{LST}}_{i}\)	\(\mathit{Min}{\mathit{LST}}_{i}\)
3	0.216	-0.479	-0.479	0.317	-0.307

The results obtained clearly show that the level-sets remain less than the radius in which the crack front was located. This means that the crack bottom has been correctly located by method UPWIND.