v1.01.413 ZZZZ413 — Validating the printing in MED format of subdot elements

Summary:

The objective is to validate the printing in MED format of the sub-dot elements. The test case validates the following impressions:

• multifibre beams,

• pipes,

• multilayer plates with and without eccentricity,

• grills with eccentricity.

An elastic calculation is carried out in order to obtain a stress, displacement or temperature field. The position of the sub-points as well as the value of the components of the field of are tested.

• 1. Reference problem
  • 1.1. Geometry used
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Benchmark solution
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainties about the solution
• 3. Modeling A
  • 3.1. Characteristics of the mesh
  • 3.2. Tested sizes and results
• 4. B modeling
  • 4.1. Characteristics of the mesh
  • 4.2. Tested sizes and results
• 5. C modeling
  • 5.1. Characteristics of the mesh
  • 5.2. Tested sizes and results
• 6. D modeling
  • 6.1. Characteristics of the mesh
  • 6.2. Tested sizes and results
• 7. E modeling
  • 7.1. Characteristics of the mesh
  • 7.2. Tested sizes and results
• 8. F modeling
  • 8.1. Characteristics of the mesh
  • 8.2. Tested sizes and results
• 9. G modeling
  • 9.1. Characteristics of the mesh
  • 9.2. Tested sizes and results
• 10. Summary of results