3. Supported loads

The available loads are as follows:

• “ CONTACT “

Allows you to define the areas subject to contact conditions.

Supported modeling: CABLE

• “ FORCE_POUTRE “

Allows line forces to be applied

Supported modeling: CABLE

• “ INTE_ELEC “

Allows you to apply the force of LAPLACE acting on a main conductor, due to the presence of a secondary conductor that is not necessarily right in relation to this main conductor.

Supported modeling: CABLE.

• “ PESANTEUR “

Allows you to apply a loading type of gravity.

Supported models: CABLE, CABLE_POULIE

Note:

• Follower load possible in the case of a type load FORCE_POUTRE.

• Possible contact between beam and surface [R5.03.50].