3. Supported loads

The available loads are as follows:

• “CONTACT”

Allows you to define the areas subject to contact conditions.

Supported models: POU_D_T, POU_D_E

• “EPSI_INIT”

Allows you to apply an initial deformation loading.

Supported models: POU_D_T, POU_D_E

• “FORCE_ELEC”

Allows you to apply the force of LAPLACE acting on a main conductor, due to the presence of a right secondary conductor.

Supported models: POU_D_T, POU_D_E

• “FORCE_POUTRE”

Allows line forces to be applied

Supported models: POU_D_T, POU_D_E, BARRE

• “INTE_ELEC”

Allows you to apply the force of LAPLACE acting on a main conductor, due to the presence of a secondary conductor that is not necessarily right in relation to this main conductor.

Supported models: POU_D_T, POU_D_E

• “PESANTEUR”

Allows you to apply a loading type of gravity.

Supported models: POU_D_T, POU_D_E, BARRE

Note:

Possible contact between beam and surface [R5.03.50].