Supported loads
=====================

The available loads are as follows:

• 'CONTACT'

Allows you to define the areas subject to contact conditions.

Supported models: POU_D_T, POU_D_E

• 'EPSI_INIT'

Allows you to apply an initial deformation loading.

Supported models: POU_D_T, POU_D_E

• 'FORCE_ELEC'

Allows you to apply the force of LAPLACE acting on a main conductor, due to the presence of a right secondary conductor.

Supported models: POU_D_T, POU_D_E

• 'FORCE_POUTRE'

Allows line forces to be applied

Supported models: POU_D_T, POU_D_E, BARRE

• 'INTE_ELEC'

Allows you to apply the force of LAPLACE acting on a main conductor, due to the presence of a secondary conductor that is not necessarily right in relation to this main conductor.

Supported models: POU_D_T, POU_D_E

• 'PESANTEUR'

Allows you to apply a loading type of gravity.

Supported models: POU_D_T, POU_D_E, BARRE

Note:

Possible contact between beam and surface [:ref:`R5.03.50 <R5.03.50>`].