Modeling A
==============


Characteristics of modeling
-----------------------------------

Modeling D_ PLAN_HHMS


Characteristics of the mesh
----------------------------


* Number of knots: 981


* Number of meshes: 80 of type SEG3 and 300 of type QUAD8

The following post-processing nodes are defined:


* :math:`\mathit{NBASE}`: at the base of the right edge


* :math:`\mathit{NTROU}`: in the middle of the opening


* :math:`\mathit{NSUP}`: at the top of the right edge

The travel limit conditions imposed are:


* On side :math:`\mathit{BAS}`: :math:`\mathit{DY}=0` and :math:`\mathit{PRE}2=0`


* On sides :math:`\mathit{GAUCHE}` and :math:`\mathit{DROIT}`: :math:`\mathit{DX}=0` and :math:`\mathit{PRE}2=0`


* On side :math:`\mathit{HAUT}`: :math:`\mathit{PRE}1=0`


Tested sizes and results
------------------------------

Hydraulic pressure values :math:`\mathit{PRE}1` (knowing that :math:`\mathit{PRE}2=0` :math:`\forall t` on the right edge):


.. csv-table::

    "**N** node", "**Instant** [sec]", "**Reference** [Pa]"
    ":math:`\mathit{NTROU}` ", "5.10-3", "0."
    ":math:`\mathit{NBASE}` ", "0.2", "-9810."
    ":math:`\mathit{NTROU}` ", "0.2", "4905."
    ":math:`\mathit{NSUP}` ", "0.2", "19620."


**Table** 3.3-1: Summary of reference values