B modeling
=============


Characteristics of modeling
-----------------------------------

Same case as before but in axisymmetric. The expected results are different as a result of integration:

:math:`{\mathrm{\int }}_{\Gamma }{M}_{11}\mathrm{.}\nu \mathrm{=}{M}_{11}\mathrm{.}\nu {\mathrm{\int }}_{0}^{1}{\mathrm{\int }}_{0}^{1}r\mathit{dr}d\theta \mathrm{=}0.5{M}_{11}\mathrm{.}\nu`

The modeling used is AXIS_HH2S.


Characteristics of the mesh
----------------------------

Number of knots: 805

Number of meshes and types: 406 meshes, 206 SEG3et 200 QUAD8


Tested sizes and results
------------------------------


.. csv-table::

    "**Identification**", "**Reference Type**", "**Value**", "**Tolerance (** :math:`\text{\%}` **)**"
    "Component :math:`\mathrm{INTE}\text{\_}\mathrm{FH11}`,
    location :math:`\mathrm{MDROITE}` ", "'AUTRE_ASTER'", "-1.0E-10"," 0.1%"
    "Component :math:`\mathrm{INTE}\text{\_}\mathrm{FH11}`,
    location :math:`\mathrm{MMIL}` ", "'AUTRE_ASTER'", "1.0E-10"," 0.1%"
    "Component :math:`\mathrm{INTE}\text{\_}\mathrm{FH11}`,
    location :math:`\mathrm{MGAUCHE}` ", "'AUTRE_ASTER'", "1.0E-10"," 0.1%"


The hydraulic flow is tested at the first Gauss point of cell :math:`{M}_{401}` at order number 5:


.. csv-table::

    "**Identification**", "**Reference Type**", "**Value**", "**Tolerance (** :math:`\text{\%}` **)**"
    "Component :math:`\mathrm{FH11}` ", "'NON_REGRESSION'", "2.00136E-10"," 0.1%"
    "Component :math:`\mathrm{FH22}` ", "'NON_REGRESSION'", "0. "," 0.1%"