Modeling A
==============


Characteristics of modeling
-----------------------------------

This is a D_ PLAN_HM modeling using quadratic HM- XFEM elements.


Characteristics of the mesh
----------------------------

The block on which the modeling is performed is divided into 625 QUAD8.


Tested sizes and results
------------------------------

We test the value of the vertical displacements for the nodes :math:`A` and :math:`B` which are located on the interface as well as the value of the pressure of the fluid in the interface at these 2 points. These values are summarized in the table below:


.. csv-table::

    "Quantities tested", "Reference type", "Reference value"
    "DY (node A below)", "'NON_REGRESSION'", "-8.731819099E-5 m"
    "DY (node A above)", "'NON_REGRESSION'", "8.731819098.E-5 m"
    "DY (node B below)", "'NON_REGRESSION'", "-4.62904976E-5 m", "-4.62904976E-5 m"
    "DY (node B above)", "'NON_REGRESSION'", "4.62904976E-5 m"
    "PRE_FL1 (node A)", "'NON_REGRESSION'", "816304Pa"
    "PRE_FL1 (node B)", "'NON_REGRESSION'", "712838Pa"



notes
---------

The pore pressure field and the amplified deformation (X1000) (Figure) were also post-treated using SALOME.

**Figure** 3.4-a **: Field of** pre**s** amplified pore and deformed (X1000)


.. image:: images/10000000000004A7000003258BAA27867A05AD2F.png
    :width: 6.689in
    :height: 4.5209in


.. _refImage_10000000000004A7000003258 BAA27867A05AD2F .png: