4. B modeling#
4.1. Characteristics of modeling#
3D modeling — MAZARS as a law of damage
4.2. Characteristics of the mesh#
Number of nodes: |
209 |
Number of meshes: |
10 of type HEXA20 |
42 of type QUAD8 |
The following mechanical boundary conditions are imposed:
\(\mathit{FIXE}\) |
|
\(\mathit{FIXE1}\) |
|
\(\mathit{ABFE}\) |
|
\(\mathit{CDHG}\) |
|
\(\mathit{DAEH}\) |
|
\(\mathit{BCGF}\) |
|
To simulate wetting, the load consists of the application of capillary pressure on the face \(\mathit{FIXE1}\) with a value \(\mathit{PRE1}\mathrm{=}37.1\mathit{MPa}\) which decreases over time.
4.3. Tested sizes and results#
The component
of the stress is tested at time 1 and the capillarity value \(\mathit{PRE1}\) at time 1 is tested at the group of nodes \(E\).
Values of
:
Instant |
Reference Type |
Reference |
Tolerance (%) |
|
|
0.001 |
\(\mathit{PRE1}\) values:
Instant |
Reference Type |
Reference |
Tolerance (%) |
|
|
0.001 |