F modeling
==============


Characteristics of modeling
------------------------

3D Modeling_ GRAD_INCO.


Characteristics of the mesh
----------------------------

Number of knots: 20

Number and types of meshes: 1 HEXA20, 6 QUAD8, 6, 12 SEG3.


Tested sizes and results
-------------------------------

The problem considered here is homogeneous and identical to problem :math:`C` (modeling :math:`C`). the constraints (or internal variables) are therefore identical at the various gauss points.

The following values are recovered at time 0.5 and 0.7: the component :math:`{\mathrm{\sigma }}_{\mathit{yy}}` of the stress tensor ('SIEF_ELGA', 'SIYY'), the work-hardening variable :math:`\mathrm{\kappa }` ('VARI_ELGA', 'V1') and the porosity :math:`f` ('VARI_ELGA', 'V2') and the porosity ('', 'V2').

The following table summarizes the values obtained by the Z-set finite element calculation software.


.. csv-table::

    "**INST**", "**Identification**", "**Reference Value**", "**Type**", "**Tolerance**"
    "0.5"," SIYY ", "403.4358"," SOURCE EXTERNE "," RELATIF — 1%"
    "0.7"," SIYY ", "445.9804"," SOURCE EXTERNE "," RELATIF — 1%"
    "0.5", "V1", "0.1117156"," SOURCE EXTERNE "," RELATIF — 1%"
    "0.7", "V1", "1.145363"," SOURCE EXTERNE "," RELATIF — 1%"
    "0.5", "V2", "0.01"," SOURCE EXTERNE "," RELATIF — 1%"
    "0.7", "V2", "0.01"," SOURCE EXTERNE "," RELATIF — 1%"