C modeling
==============


Characteristics of modeling
-----------------------------------

These are the same modeling characteristics as modeling A but under plane constraints.


Characteristics of the mesh
----------------------------

These are the same mesh characteristics as modeling A.


Tested sizes and results
------------------------------

Contact pressures are tested as for modeling A. The location of the nodes that store the contact degrees of freedom, whose values are tested, is illustrated on the [].


.. csv-table::

    "**No**", "**Identification**", "**Reference**", "**Tolerance**"
    "", "LAGS_C for N10", "0.0000000E+00", "1.0E-12"
    "", "LAGS_C for N60", "-5.6047281D+04"," 5.0%"
    "1"," LAGS_C for N56", "-5.3536786D+04"," 5.0%"
    "", "LAGS_C for N52", "-4.4909070D+04"," 5.0%"
    "", "LAGS_C for N9", "0.0000000E+00", "1.0E-12"
    "", "LAGS_C for N10", "0.0000000E+00", "1.0E-12"
    "", "LAGS_C for N60", "-1.6263864E+05"," 5.0%"
    "2"," LAGS_C for N56", "-1.1063071E+05"," 5.0%"
    "", "LAGS_C for N52", "-9.1544228E+04"," 5.0%"
    "", "LAGS_C for N9", "0.0000000E+00", "1.0E-12"
    "", "LAGS_C for N10", "0.0000000E+00", "1.0E-12"
    "", "LAGS_C for N60", "0.0000000E+00", "1.0E-12"
    "3"," LAGS_C for N56", "-1.7966654E+05"," 5.0%"
    "", "LAGS_C for N52", "-1.4075455E+05"," 5.0%"
    "", "LAGS_C for N9", "0.0000000E+00", "1.0E-12"
    "", "LAGS_C for N10", "0.0000000E+00", "1.0E-12"
    "", "LAGS_C for N60", "0.0000000E+00", "1.0E-12"
    "4"," LAGS_C for N56", "-3.4348434E+05"," 5.0%"
    "", "LAGS_C for N52", "-1.9708554E+05"," 5.0%"
    "", "LAGS_C for N9", "0.0000000E+00", "1.0E-12"