v6.03.150 SSNP150 — Method of manufactured solutions in 2D contact and large deformations

Summary:

The objective of this test is to verify the modeling of 2D contact in large deformations using the method of manufactured solutions [bib1].

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Benchmark solution
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainties about the solution
  • 2.4. Bibliographical references
• 3. Modeling A
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
• 4. B modeling
  • 4.1. Characteristics of modeling
  • 4.2. Characteristics of the mesh
  • 4.3. Tested sizes and results
• 5. C modeling
  • 5.1. Characteristics of modeling
  • 5.2. Characteristics of the mesh
  • 5.3. Tested sizes and results
• 6. D modeling
  • 6.1. Characteristics of modeling
  • 6.2. Characteristics of the mesh
  • 6.3. Tested sizes and results
• 7. E modeling
  • 7.1. Characteristics of modeling
  • 7.2. Characteristics of the mesh
  • 7.3. Tested sizes and results
• 8. Modeling f
  • 8.1. Characteristics of modeling
  • 8.2. Characteristics of the mesh
  • 8.3. Tested sizes and results
• 9. Summary of results