S modeling
==============


Characteristics of modeling
------------------------

A D_ PLAN modeling is used for solid elements with the CONTINUE method for the treatment of CONTACT. We test the PENALISATION method with generalized Newton.


Characteristics of the mesh
----------------------------

The mesh is the same as that of modeling A.


Tested sizes and results
------------------------------


.. csv-table::

    "**Identification**", "**Reference Value**", "**Reference Type**", "**Tolerance**"
    "LAGS_Cau node :math:`\mathit{N14}` ", "—1.E+5", "'ANALYTIQUE'", "1%"
    "LAGS_Cau point :math:`A` ", "—1.E+5", "'ANALYTIQUE'", "1%"
    "LAGS_Cau point :math:`B` ", "—1.E+5", "'ANALYTIQUE'", "1%"
    "DYau node :math:`\mathit{N14}` ", "-0.05", "'ANALYTIQUE'", "1%"
    "DYau point :math:`A` ", "-0.05", "'ANALYTIQUE'", "1%"
    "DYau point :math:`B` ", "-0.05", "'ANALYTIQUE'", "1%"



notes
---------

In this modeling, we use PENTA18 meshes that have been transformed by the CREA_MAILLAGE operator.