R modeling
==============


Characteristics of modeling
-----------------------------------

3D modeling is used for solid elements with method CONTINUE for the treatment of CONTACT. The contact surfaces facing each other are made up of TRIA6 elements.


Characteristics of the mesh
----------------------------


.. csv-table::

    "Number of knots:", "1458"
    "Number of meshes and types:", "256 PENTA18, 128 TRIA6"



Tested sizes and results
------------------------------


.. csv-table::

    "**Identification**", "**Reference Value**", "**Reference Type**", "**Tolerance**"
    "LAGS_Cau node :math:`\mathit{A21}` ", "—1.E+5", "'ANALYTIQUE'", "0.1%"
    "LAGS_Cau point :math:`\mathit{A22}` ", "—1.E+5", "'ANALYTIQUE'", "0.1%"
    "LAGS_Cau point :math:`\mathit{A23}` ", "—1.E+5", "'ANALYTIQUE'", "0.1%"
    "LAGS_Cau point :math:`\mathit{A24}` ", "—1.E+5", "'ANALYTIQUE'", "0.1%"
    "MAX of LAGS_Csur the surface", "—1.E+5", "'ANALYTIQUE'", "0.1%"
    "MIN of LAGS_Csur the surface", "—1.E+5", "'ANALYTIQUE'", "0.1%"
    "DZau point :math:`\mathit{A21}` ", "-0.05", "'ANALYTIQUE'", "0.1%"
    "DZau point :math:`\mathit{A22}` ", "-0.05", "'ANALYTIQUE'", "0.1%"
    "DZau point :math:`\mathit{A23}` ", "-0.05", "'ANALYTIQUE'", "0.1%"
    "DZau point :math:`\mathit{A24}` ", "-0.05", "'ANALYTIQUE'", "0.1%"



notes
---------

In this modeling, we use PENTA18 meshes that have been transformed by the CREA_MAILLAGE operator.