L modeling
==============


Characteristics of modeling
-----------------------------------

A D_ PLAN modeling is used for solid elements with the GCP method for the treatment of CONTACT.


Characteristics of the mesh
----------------------------

The same mesh is used as for modeling A.


.. csv-table::

    "Number of nodes:", "313"
    "Number of meshes and types:", "265 QUAD4et 132 SEG2"



Tested sizes and results
------------------------------


.. csv-table::

    "**Identification**", "**Reference Value**", "**Reference Type**", "**Tolerance**"
    "SIYYau node :math:`\mathit{N14}` ", "—1.E+5", "'ANALYTIQUE'", "2.13%"
    "SIYYau point :math:`A` ", "—1.E+5", "'ANALYTIQUE'", "7.5%"
    "SIYYau point :math:`B` ", "—1.E+5", "'ANALYTIQUE'", "7.5%"
    "DYau node :math:`\mathit{N14}` ", "-0.05", "'ANALYTIQUE'", "2.13%"
    "DYau point :math:`A` ", "-0.05", "'ANALYTIQUE'", "0.7%"
    "DYau point :math:`B` ", "-0.05", "'ANALYTIQUE'", "0.7%"



notes
---------

Discreet formulations do not verify the *patch-test* unlike continuous formulation, which is why the tolerances are looser.