D modeling ============== Characteristics of modeling ----------------------------------- The beam is modeled by DKTG elements. 16 elements are used in the longitudinal direction :math:`X` and only one in the transverse direction :math:`Y`. Reinforced concrete is modelled by the DHRC law of behavior. The parameters of the law are obtained using the eponymous identification plugin in Salome-Meca. The material data used is defined in :ref:`1.2 `. Tested sizes and results ------------------------------ The values are based on experimental results (SOURCE_EXTERNE). The arrow is the arrow in the center of the beam. Press reaction on center of edge A: .. csv-table:: "**Arrow (m)**", "**Height**", "", "**Location**", "**Reference type**", "**Reference**", "**Tolerance**" "3.00E-03"," REAC_NODA ", "DY", "DY", "Group: A", "SOURCE_EXTERNE ", "2.95780E+04", "0.7" "0.50E-02"," REAC_NODA ", "DY", "DY", "Group: A", "SOURCE_EXTERNE ", "4.02560E+04", "0.7" "0.7E-02"," REAC_NODA ", "DY", "DY", "Group: A", "SOURCE_EXTERNE ", "4.98640E+04", "0.7" "1.1E-02"," REAC_NODA ", "DY", "DY", "Group:A", "SOURCE_EXTERNE ", "6.97240E+04", "0.7" "1.6E-02"," REAC_NODA ", "DY", "DY", "Group: A", "SOURCE_EXTERNE ", "8.95840E+04", "0.7" "1.9E-02"," REAC_NODA ", "DY", "DY", "Group: A", "SOURCE_EXTERNE ", "9.9940E+04", "0.75" "5.0E-02"," REAC_NODA ", "DY", "DY", "Group:A", "SOURCE_EXTERNE ", "1.1768E+05", "2,2" .. image:: images/10000000000001E000000120E73A51F0D4782A2D.png :width: 5.0008in :height: 3.0008in .. _RefImage_10000000000001E000000120E73A51F0D4782A2D.png: Figure 6.2-a: Support reaction as a function of the arrow in the center