v5.01.123 SDND123 — Linear mode calculation for a system with 2 degrees of freedom with an elastic bilateral stop

Summary:

The objective of this test is to validate the non-linear mode calculation with the operator MODE_NON_LINE.

The system is particularly validated with a non-linearity such as a bilateral stop.

Post-treatments are also carried out with CALC_STABILITE and REST_MODE_NONL.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Benchmark solution
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainties about the solution
  • 2.4. Bibliographical references
• 3. Modeling A
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
• 4. Summary of results