C modeling
==============

**Modeling: COQUE (QUAD9 + SEG3)**


.. image:: images/Object_4.svg
    :width: 598
    :height: 247


.. _RefImage_Object_4.svg:


Characteristics of modeling
-----------------------------------

Because of the boundary conditions and loads, the modeling is independent of the width of the sides :math:`\mathit{AD}` and :math:`\mathit{BC}` (the temperature distribution is uniform along the width).


Characteristics of the mesh
----------------------------

We have 33 knots in total

5 QUAD9 stitches on the average surface of the shell

1 SEG3 mesh on the BC side


Tested values
---------------


.. csv-table::

    "**Identification**", "**Reference**", "**Aster**", "**% difference**", "**tolerance**"
    "Location", ":math:`T(°C)` ", "", "", ""
    ":math:`x/L=0.0` ", "593.333", "593.333", "0.000"," 5%"
    ":math:`x/L=0.1` ", "512.778", "517.947", "1.008"," 5%"
    ":math:`x/L=0.2` ", "446.111", "451.207", "1.142"," 5%"
    ":math:`x/L=0.3` ", "393.333", "395.841", "0.638"," 5%"
    ":math:`x/L=0.4` ", "348.889", "349.658", "0.220"," 5%"
    ":math:`x/L=0.5` ", "312.778", "311.722", "-0.338"," 5%"
    ":math:`x/L=0.6` ", "279.444", "280.993", "0.554"," 5%"
    ":math:`x/L=0.7` ", "254.444", "256.673", "0.876"," 5%"
    ":math:`x/L=0.8` ", "237.778", "238.125", "0.146"," 5%"
    ":math:`x/L=0.9` ", "221.111", "224.854", "1.693"," 5%"
    ":math:`x/L=1.0` ", "213.333", "216.516", "1.492"," 5%"



notes
---------

As expected, the temperature distribution is uniform across the width. All the results obtained are clearly within the accepted tolerance range.