Modeling A
==============


Characteristics of modeling A
-------------------------------------

Modeling AXIS_FOURIER in mode 1 (the decomposition of the load is carried out according to mode 1).


Characteristics of the mesh
----------------------------

Number of knots: 455

Number of meshes and types: 400 TRIA3, 160 QUAD4


Tested sizes and results
------------------------------

For :math:`\theta =45`,


.. csv-table::

    "**Size**", "**Component**", "**Location**", "**Reference Type**", "**Reference Value**", "**Tolerance**"
    "DEPL ", "DX", "Point D (:math:`\mathit{N461}`)", "'ANALYTIQUE'", ":math:`1.683587\times {10}^{-8}` m", "0.25%"
    "DEPL ", "DY", "Point D (:math:`\mathit{N461}`)", "'ANALYTIQUE'", ":math:`0.0` ", "1.E-14Pa"
    "DEPL ", "DZ", "Point D (:math:`\mathit{N461}`)", "'ANALYTIQUE'", ":math:`1.683587\times {10}^{-8}` "," 0.25%"
    "DEPL ", "DX", "Point C (:math:`\mathit{N460}`)", "'ANALYTIQUE'", ":math:`1.683587\times {10}^{-8}` "," 0.25%"
    "DEPL ", "DY", "Point C (:math:`\mathit{N460}`)", "'ANALYTIQUE'", ":math:`-3.36717\times {10}^{-10}` "," 5.2%"
    "DEPL ", "DZ", "Point C (:math:`\mathit{N460}`)", "'ANALYTIQUE'", ":math:`1.683587\times {10}^{-8}` "," 0.25%"
    "SIGM_ELNO "," SIXX ", "Point B (:math:`\mathit{N5}`)", "'ANALYTIQUE'", ":math:`-176.77` "," 1.3%"
    "SIGM_ELNO "," SIYY ", "Point B (:math:`\mathit{N5}`)", "'ANALYTIQUE'", ":math:`-412.48` "," 3.7%"
    "SIGM_ELNO "," SIZZ ", "Point B (:math:`\mathit{N5}`)", "'ANALYTIQUE'", ":math:`-176.77` "," 2.4%"
    "SIGM_ELNO "," SIXY ", "Point B (:math:`\mathit{N5}`)", "'ANALYTIQUE'", ":math:`0.0` ", "5.0 Pa"
    "SIGM_ELNO "," SIXX ", "Point A (:math:`\mathit{N1}`)", "'ANALYTIQUE'", ":math:`0.0` ", "45.0 Pa"
    "SIGM_ELNO "," SIYY ", "Point A (:math:`\mathit{N1}`)", "'ANALYTIQUE'", ":math:`0.0` ", "105.0 Pa"
    "SIGM_ELNO "," SIZZ ", "Point A (:math:`\mathit{N1}`)", "'ANALYTIQUE'", ":math:`0.0` ", "45.0 Pa"
    "SIGM_ELNO "," SIXY ", "Point A (:math:`\mathit{N1}`)", "'ANALYTIQUE'", ":math:`0.0` ", "30.0 Pa"



notes
---------

The test reveals the need, in models with linear elements, to use very fine meshes in order to achieve satisfactory results.