v3.04.100 SSLV100 - Hollow cylinder in plane deformations

Summary:

This test makes it possible to validate the plane deformation elements on the following functionalities:

• distributed pressure,

• stiffness matrix,

• mandatory trips:

• by degree of freedom,

• per element face.

It includes 4 models.

The first 3 correspond to elements of different types (linear and quadratic).

The last one validates the movements imposed by side (blocking the normal component).

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
• 2. Benchmark solution
  • 2.1. Calculation method used for the reference solution
  • 2.2. Benchmark results
  • 2.3. Bibliographical references
• 3. Modeling A
  • 3.1. Modelling characteristics: d-plan (QUAD4 + TRIA3)
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results
  • 3.4. notes
• 4. B modeling
  • 4.1. Modelling characteristics: d-plan (QUAD8 + TRIA6)
  • 4.2. Characteristics of the mesh
  • 4.3. Tested sizes and results
  • 4.4. notes
• 5. C modeling
  • 5.1. Modelling characteristics: d-plan (QUAD9)
  • 5.2. Characteristics of the mesh
  • 5.3. Tested sizes and results
  • 5.4. notes
• 6. D modeling
  • 6.1. Modelling characteristics: d-plan (QUAD4 + TRIA3)
  • 6.2. Characteristics of the mesh
  • 6.3. Tested sizes and results
  • 6.4. notes
• 7. Summary of results