J modeling
==============


Characteristics of modeling
-----------------------------------

Modeling: 3D.

Law of elasto-plastic behavior of type VMIS_ISOT_LINE.

The pre-deformation introduced via the keyword PRE_EPSI in AFFE_CHAR_MECA is defined by an analytical function.

This calculation consists of a 3D modeling of the E model, which is axisymmetric.


Characteristics of the mesh
----------------------------

The mesh is identical to that of modeling I.


Tested sizes and results
------------------------------

Only the point in the middle of the crack front shown is tested.


.. csv-table::

    "**Identification**", ":math:`G` **(Reference)**", ":math:`\text{\%}` Tolerance"
    "Crown 1: :math:`\mathrm{Rinf}=1`, :math:`\text{Rsup}=5` ", "0.4366"," :math:`\text{0.0 1 \%}`"
    "Crown 2: :math:`\mathrm{Rinf}=5`, :math:`\text{Rsup}=10` ", "0.4362"," :math:`\text{0.0 1 \%}`"
    "Crown 3: :math:`\mathrm{Rinf}=10`, :math:`\text{Rsup}=20` ", "0.4362"," :math:`\text{0.0 1 \%}`"
    "Crown 4: :math:`\mathrm{Rinf}=20`, :math:`\text{Rsup}=30`", "0.4362"," :math:`\text{0.0 1 \%}`"