B modeling
==============

Characteristics of modeling and meshing
--------------------------------------------------

Same characteristics as modeling :math:`A`, only the type of beam element changes. In this case it's POU_D_EM elements.


Tested sizes and results
------------------------------

As already specified in the introduction, all the reference results are of type AUTRE_ASTER obtained with the POU_D_E modeling.

The table below summarizes the results obtained by the POST_ELEM command, with the MASS_INER keyword.


.. csv-table::

    "**Sizes**", "**Values**
    **References**", "**Precision**"
    "MASSE ", "5.8576E+02", "1E—06"
    "CDG_X ", "2.0000E+00", "1E—06"
    "CDG_Z ", "2.0397E+00", "1E—06"
    "IX_PRIN_G ", "1.5656E+03", "1E—06"
    "IY_PRIN_G ", "1.8182E+03", "1E—06"
    "IZ_PRIN_G ", "2.2349E+03", "1E—06"



.. csv-table::

    "**Mode**", "**PARA**", "**Reference Value**", "**Precision**"
    "1"," FREQ ", "9.98316178503", "1E—06"
    "2"," FREQ ", "12.3054090119", "1E—06"
    "3"," FREQ ", "13.0421930932", "1E—06"
    "4"," FREQ ", "19.0267560923", "1E—06"
    "5"," FREQ ", "22.2977469834", "1E—06"
    "6"," FREQ ", "26.7653558109", "1E—06"
    "7"," FREQ ", "33.6499455758", "1E—06"
    "8"," FREQ ", "34.476790496", "1E—06"
    "9"," FREQ ", "35.1296888165", "1E—06"
    "10"," FREQ ", "36.8646125525", "1E—06"
    "1"," MASS_EFFE_UN_DX ", "0.240393876317", "1E—06"
    "2"," MASS_EFFE_UN_DX ", "0.433081172981", "1E—06"
    "3"," MASS_EFFE_UN_DY ", "0.527057012444", "1E—06"
    "3"," MASS_EFFE_UN_DZ ", "4.1536989003E-4", "1E—06"
    "4"," MASS_EFFE_UN_DX ", "0.0799412335197", "1E—06"
    "5"," MASS_EFFE_UN_DY ", "0.136506718973", "1E—06"
    "6"," MASS_EFFE_UN_DY ", "0.0630112344329", "1E—06"
    "7"," MASS_EFFE_UN_DY ", "6.12175711067E-4", "1E—06"
    "8"," MASS_EFFE_UN_DX ", "1.47389085571E-3", "1E—06"
    "9"," MASS_EFFE_UN_DX ", "0.0126681569373", "1E—06"