3. B modeling#

3.1. But#

Modeling A does not ensure that the material parameters have been translated correctly. The aim of this test is to complete that.

3.2. Description#

On the same model as modeling A, a pressure is applied to the upper face of the cube strong enough to leave the elastic part of the law. The calculation is started without an initial state.

3.3. Principle of validation#

After verifying that the material parameters were translated correctly in the command file EPX created, non-regression tests are applied to this calculation.

3.4. Tested values#

Mesh

Component

Point

Reference Value

Tolerance

M1

\(\mathit{SIXX}\)

1

1

-150717574.84

1E-6

M1

\(\mathit{SIYY}\)

3

3

-150717574.84

1E-6

M1

\(\mathit{SIZZ}\)

5

5

-150729740.85

1E-6