.. _V1.01.362:

**v1.01.362** ZZZZ362 - Checking the consistency of the fields produced by the X- FEM sub-division
====================================================================================================

**Summary**

This test has no physical meaning, it is a computer test.

The fields produced by the sub-division X- FEM correspond to the cham_elem produced by the calculation options TOPOSE and TOPOFA, and stored in the sd_modele_xfem [:ref:`D4.10.02 <D4.10.02>`]. The sizing of these cham_elem must be done in the same way for all the X- FEM elements belonging to the same "topological" category. We consider 4 categories:


* finite elements assigned to main 3D meshes;


* finite elements assigned to 3D edge meshes;


* finite elements affected on main 2D meshes;


* finite elements affected on 2D edge meshes;

The objective of this test is to ensure that all the models that can be affected on a given mesh lead to the same dimensioning of these fields. Otherwise, the test fails. 2 "models" are considered



.. _DdeLink__5078_908893188:

* **modeling A**: comparison of models MECANIQUE /3D, MECANIQUE /3D/ /3D/ CONTACT, THERMIQUE /3D, MECANIQUE /3D_HM, MECANIQUE /3D_HM/ CONTACT


* **B modeling**: comparison of models MECANIQUE /C_ PLAN, MECANIQUE /C_, /C_, /C_ PLAN/CONTACT, MECANIQUE /D_ PLAN, MECANIQUE PLAN CONTACT MECANIQUE AXIS MECANIQUE/AXIS/CONTACT, THERMIQUE/PLAN, THERMIQUE/AXIS, MECANIQUE /D_ PLAN_HM, MECANIQUE /D_ purpose PLAN_HM CONTACT


.. _RefNumPara__11655_1489988600:


.. toctree::
    :hidden:

    self

.. toctree::
    :maxdepth: 2
    :numbered:

    Principe_du_test
    Mod_lisation_A
    Mod_lisation_B