v1.01.235 PLEXU01 — Basic validation of the CALC_EUROPLEXUS order

Summary:

The objective of this test is to validate the command CALC_EUROPLEXUS which starts a EUROPLEXUS calculation (fast dynamics code) from a calculation data set in Code_Aster. We check that the results retrieved by Code_Aster following calculation EUROPLEXUS are indeed those calculated by EUROPLEXUS alone.

• 1. Reference problem
  • 1.1. Geometry
  • 1.2. Material properties
  • 1.3. Boundary conditions and loads
  • 1.4. Initial conditions
• 2. Reference solution
  • 2.1. Calculation method
  • 2.2. Reference quantities and results
  • 2.3. Uncertainty about the solution
• 3. Modeling A
  • 3.1. Characteristics of modeling
  • 3.2. Characteristics of the mesh
  • 3.3. Tested sizes and results