4. C modeling#
4.1. Characteristic of modeling#
Modeling C inherits modeling A, except that we use the “FELLENIUS” method to calculate the FS.
4.2. Tested sizes and results#
We test the value of the slippage indicator (DX from field DEPL_NOEU) on the same N391 node as modeling A. The result is shown in Tableau 6.
The values of the safety factors are also tested during the refinement of the mesh and the geometric parameters contained in the table in output of the macro-command. The results are shown in Tableau 7.
Table 6: Reference value at node N391 of the cham_defo (Modeling A)
Identification |
Reference type |
Reference value |
Tolerance |
X |
“NON_REGRESSION” |
1.0 |
|
Table 7: Reference values of the FS table and of the geometric parameters of the circular fracture surface (Modeling A)