1. But

This macro command aims to automate the post-processing of data from command GENE_ACCE_SEISME. It performs the following tasks:

• printing a figure by accelerogram, i.e. by direction and by drawing;

• printing of a figure of all the accelerograms for each direction;

• calculation of the speeds and then the movements of the signals;

• Impression of a figure of all the movements for each direction;

• printing of a figure containing the indicators of harmfulness for each direction;

• printing of a statistical table on harmful indicators;

• calculation of signal spectra and calculation of the average spectrum by direction;

• impression of a figure with target spectrum and average spectrum by direction;

• impression of a figure containing all spectra as well as the target spectrum and the average spectrum by direction;

• calculation of the plus and minus spectra \(\mathrm{\sigma }\);

• impression of a figure with the plus and minus \(\mathrm{\sigma }\) spectra as well as the \(\mathrm{\sigma }\) target spectrum for each direction;

• correction of the average spectrum (by a multiplying factor) so that it is not less than the target spectrum on a given frequency band for each direction;

• calculation and printing on a figure of the geometric mean of the mean spectra in the vertical directions if the dimension of the problem is greater than or equal to 2.

The figures and tables are created in the REPE_OUT folder in the temporary execution directory [U4.12.03].